Sharp UX-B30 - Manual (Page 66)

Auto-Cordless Fax Control (answering with an extension phone in TEL mode)
62
1
Answer the extension phone when it
rings.
2
If you hear a soft fax tone, wait until your fax responds (the extension
phone will go dead), then hang up.
3
If the fax doesn't respond, or if the other party first talks to you and then
wants to send a fax, press once and twice on the extension
phone (only on a tone dial phone). This signals the fax to begin
reception. Hang up.
•
The above step is necessary if you have set the Fax Signal Receive setting
to NO.
•
Your fax will not accept the signal to begin reception ( ) if a
document is loaded in its feeder.
Phone goes dead
Beep
Auto-Cordless Fax Control
(answering with an extension phone in TEL
mode)
Important: If a document is loaded in the machine’s feeder, remove it before
performing the steps below. (Fax reception is not possible when a document
is in the feeder.)
You can also start fax reception in TEL mode by answering any extension
phone connected to the same line as the fax machine-even a cordless phone.
all.book Page 62 Tuesday, June 1, 2004 4:24 PM