Sharp UX-B30 - Manual (Page 55)

Sending a Fax by Automatic Dialling
51
2. Send
ing
Fa
x
e
s
1
If you are sending a fax, load the
document(s).
•
If desired, press to set the
resolution and/or contrast.
2
Press once. appears in the display, followed by the last
number dialled. Make sure the number that appears is the number you
wish to dial.
3
If you are sending a fax, press . Dialling begins.
If you are making a phone call, lift the handset. Dialling begins.
Note: If the transmission is unsuccessful and DOCUMENT JAMMED appears
in the display, remove the document as explained on page 104. (This may
occur if the other fax machine doesn’t respond properly when you attempt to
send the document.)
AUFLÖS./
EMPFANG
START/
SPEICHER
Redial
You can automatically redial the last number dialled on the fax machine. This
procedure can be used to send a fax or make a phone call.
Automatic redialling
If you use automatic dialling (including Direct Keypad Dialling) to send a fax
and the line is busy, the fax machine will automatically redial the number. The
fax machine will make three redial attempts at intervals of five minutes. During
this time, RECALLING will appear in the display, followed by a two-digit
number assigned to the fax job. You will not be able to dial any other locations
while the message appears.
READY TO SEND
all.book Page 51 Tuesday, June 1, 2004 4:24 PM