Sharp UX-B30 - Manual (Page 106)

Messages and Signals
102
FAX RX IN MEMORY A fax has been received in memory because the print
cartridge needs replacement, you have run out of
printing paper, or the paper is jammed. The fax will
print out automatically when the problem is fixed.
FUNCTION MODE
has been pressed.
INK NEAR EMPTY The cartridge is nearly empty (approximately one
eighth of the ink remains).
LINE ERROR Transmission or reception was not successful. Press
to clear the message and then try again. If the
error persists, see Line error on page 97.
LOW INK The cartridge is low on ink (approximately one
quarter of the ink remains).
MEMORY IS FULL If faxes have been received to memory because
printing is not possible (an additional message will
indicate the problem), resolve the problem so that
printing can continue (see
Substitute Reception to
Memory on page 67).
If you are attempting to transmit from memory, see
If
the memory becomes full on page 56.
If you are copying, see
If MEMORY IS FULL appears
on page 69.
MEMORY PRINTING The fax is preparing to or printing out a document
from memory.
NO # STORED This appears if you attempt to search for an auto-dial
number when none have been stored.
OFF HOOK This appears if you forgot to replace the handset after
using it to dial and send a fax. Replace the handset or
press to clear the message.
ON HOOK DIAL
has been pressed and the fax machine is waiting
for you to dial.
STOP
STOP
all.book Page 102 Tuesday, June 1, 2004 4:24 PM