Sharp UX-B30 - Manual (Page 35)

Flash Select Setting for PBX
31
1. Installation
Flash Select Setting for PBX
Note: This setting is normally only used in Germany. In other countries, you
can try changing the setting if you encounter difficulty with the default setting.
If your fax machine is connected to a PBX and the PBX uses the “Flash”
method to connect to an outside line, you must select the appropriate Flash
Select setting depending on whether your PBX line is a normal telephone line
or a high-speed line.
1
Press once and 3 times.
2
Press once and 7 times.
3
Press once.
4
Select (SHORT TIME) if your PBX
line is a normal telephone line.
Select (LONG TIME) if your PBX
line is a high-speed line.
5
Press to return to the date and time display.
STOP
Display:
The display briefly shows
your selection, then:
OPTION SETTING
FLASH SELECT
FAX SIGNAL RX
1: SHORT TIME
all.book Page 31 Tuesday, June 1, 2004 4:24 PM