Siemens SpeedStream 5450 - Manual (Page 8)

5450 Four-Port Router User’s Guide Introduction
Physical Details
Familiarize yourself with the router before installing.
Front Panel LEDs
The front panel contains the following LEDs:
Off
Power is off.
Green Power is on.
Flashing Flash write in progress.
Power
Red The Power LED briefly shows red
during power-up. This indicates that the
SpeedStream is conducting the POST
(Power-On Self Test) that is run each
time the SpeedStream is powered on.
Post error occurred if persistent.
Example Front Panel
On DSL connection is active.
DSL Port
Off No active DSL connection.
On One or more Ethernet LAN ports are
active. Ethernet
Off No active Ethernet LAN port
connection.
Off No data being transmitted or received. Activity
Flashing Data is being transmitted or received.
Internet
Off No power or bridge mode or no DSL
link.
Green DLS link is up + WAN interface + WAN
interface has IP address.
Rear Panel
DSL Port
(RJ11) Connect the RJ11 DSL cable (looks like a telephone
cord) here to use your DSL connection through an
existing phone line.
Four 10/100
Ethernet Ports Connect the RJ45 Ethernet cable here to connect
your computers, hubs, or switches to the router.
You can configure port #4 as either a LAN or WAN
port.
Power Adapter
Port Connect the supplied power adapter provided with
the router here.
Example Rear Panel
3