Siemens TC65 - Manual (Page 35)

TC65 JAVA User's Guide
Strictly confidential / Released
s
TC65 JAVA User's Guide_V05 Page 35 of 90 26.09.2005
Table 5: A typical sequence of MIDlet execution
Application Management Software MIDlet
The application management software creates a new instance of a
MIDlet .
The default (no argument)
constructor for the
MIDlet is
called; it is in the Paused state.
The application management software has decided that it is an
appropriate time for the
MIDlet to run, so it calls the
MIDlet.startApp method for it to enter the Active state.
The MIDlet acquires any
resources it needs and begins to
perform its service.
The application management software no longer needs the
application be active, so it signals it to stop performing its service
by calling the MIDlet.pauseApp method. The MIDlet stops performing its
service and might choose to
release some resources it
currently holds.
The application management software has determined that the
MIDlet is no longer needed, or perhaps needs to make room for a
higher priority application in memory, so it signals the MIDlet that
it is a candidate to be destroyed by calling the
MIDlet.destroyApp method.
If it has been designed to do so,
the
MIDlet saves state or user
preferences and performs clean
up.