Savin 3150eDNP - Manual (Page 83)

SERVICE PROGRAM MODE
62
3
User Codes
If the machine is set to use the User
Code function, operators must input
their user codes before the machine
can operate. The machine keeps count
of the number of prints made under
each user code.
In this mode, the following 20 user
codes (fixed) can be used to access the
machine: 382, 191, 182, 173, 164, 155,
146, 137, 128, 119, 482, 291, 282, 273,
264, 255, 246, 237, 228, 219
Note
❒ To prevent unauthorized users
from accessing the machine, note
down the codes and then black out
the codes from this manual.
How To Set User Code Mode (#
120)
The following procedure explains
how to set user code mode. This must
be done before a user code can be in-
put.
A
Press the {{{{Clear Modes}}}} key.
B
Hold down the
{{{{Clear/Stop}}}} key
for at least 3 seconds.
C
Enter “120” with the
{{{{Number}}}}
keys and press the {{{{#}}}} key.
D
Enter “1” (Yes) with the {{{{Number}}}}
keys and then press the {{{{#}}}} key.
E
Specify the Auto Reset time. En-
ter the desired setting with the
{{{{Number}}}} keys and press the {{{{#}}}}
TSLS01UN
TSLS01AN
TSLS011N
TSLS01VN