Sanyo VCC-WB4000P - Manual (Page 75)

Troubleshooting
B Checking Using a Memory Card
You can create a special text file in the root
directory of a memory card, and then generate
an address data file when the card is inserted.
For text input only single byte characters can be
used.
1
Create a command file (WBCMD.TXT) in
the root directory of the memory card.
☞ Editing the command file
(WBCMD.TXT)
After creating a file named “WBCMD.TXT”, use
a text editor program such as Notepad for
inputting and saving the text shown below.
2
Turn on the camera’s power, and insert
the memory card into the PC card slot.
3
After the power indicator flashes several
times and then illuminates steadily,
remove the memory card.
4
Remove the memory card, open the
newly-created data file (WBMENU.TXT)
using the computer’s text editor, and
check the address details.
☞ If you would like to modify the IP
address directly
1
Create a command file (WBCMD.TXT) in
the root directory of the memory card.
2
Use the computer’s text editor to add the
following text to the file.
Type “SET MENU” in first, and then add the
addresses that you would like to change
below it.
(Type in the address information directly to
the right of the =.)
•
IP address ! IP=
•
Subnet mask ! SUBNET=
•
Default gateway ! GATEWAY=
•
HTTP port number ! PORT=
Example:
3
Turn on the camera’s power, and insert
the memory card into the PC card slot.
4
After the power indicator flashes several
times and then illuminates steadily,
remove the memory card.
Note: If the data is not typed in correctly, the
procedure may not work correctly, so
always check the data to make sure that it
is correct.
L5AM2/XE (VCC-WB4000P) GB 2004, 2, 17
– 74 – English