Sanyo VCC-WB4000P User Manual
Page 43
Alarm Settings
C Detecting Intruders Using Both
an External Sensor and Motion
Detector Settings
You can use both an external sensor and motion
detector settings to detect alarms.
1
Set “ALARM REC USE” to “NO USE” and
then click the [SET] button.
Set to “NO USE” first so that alarms cannot
be detected while you are making the
settings. Change the setting back to “USE”
after you have finished making the settings.
2
Carry out the settings in “
A
Detecting
Intruders Using an External Sensor”.
Make the external alarm sensor settings.
(p. 38)
3
Carry out the settings in “
B
Detecting
Intruders Using Motion Detector Settings”.
Make the motion detector settings. (p. 40)
4
Set “ALARM MODE” to “AND” (example).
Available settings:
•
AND: An alarm is generated when both
the external alarm and the motion sensor
receive alarm input.
•
OR: An alarm is generated when either
the external alarm or the motion sensor
receives alarm input.
5
Change the “ALARM REC USE” setting
that was set in step 1 back to “USE”, and
then click the [SET] button.
1
4
L5AM2/XE (VCC-WB4000P) GB 2004, 2, 17
– 42 –
English