Sanyo VCC-WB4000P - Manual (Page 32)

CAMERA Settings
DAY/NIGHT Settings
A AUTO Mode Settings
Monitoring switches automatically between color
and black & white depending on the luminance
of the objects.
1
Click the [DETAIL] button in the
DAY/NIGHT field and set MODE to
“AUTO”.
2
Set “AGC Gain” to “+12dB” (example).
If the objects are dark, set the AGC Gain to
the maximum value so that images are made
brighter when they are being monitored.
Available settings: +9dB (default setting),
+12dB, +15dB
Note: When the AGC gain is increased,
sensitivity will also be increased for
dark objects and they will appear
bright, but interference will also
increase.
3
Set “LEVEL“ to “LOW” (example).
This set the luminance for switching
automatically between color and black &
white.
Available settings: LOW, MID (default
setting), HIGH
(switching at brighter
luminances)
4
Set “BURST” to “OFF” (example).
This sets the color burst settings for the video
signals from the MONITOR OUT terminal.
Depending on the connection status, some
momentary distortion in the color of the
images may occur when switching from color
to black & white images. If this happens,
change this setting to “ON”. (The same
applies to settings in other modes.)
Available settings: OFF, ON
5
Click the [SET] button.
Monitoring will switch from color to black &
white according to the set conditions.
☞ DAY/NIGHT SET Screen
The DAY/NIGHT settings can be selected from
one of four modes (AUTO, COLOR, B/W and
TIMER). Click the [DETAIL] button in the
DAY/NIGHT field to display the DAY/NIGHT SET
screen.
1,2
3
4
L5AM2/XE (VCC-WB4000P) GB 2004, 2, 17
English – 31 –