Sanyo VCC-WB4000P - Manual (Page 36)

Alarm Settings
Flow of Operations from Alarm Detection to Recording
The camera is equipped with the following alarm functions. When an intruder is detected, the images
immediately before the alarm occurred (pre-alarm images) and immediately after the alarm occurred
(post-alarm images) are recorded into the camera’s internal memory or onto an expansion memory
card. The alarm images can also be sent to a designated e-mail address.
b Detecting Intruders
b Recording and Deleting alarm images
Alarm images detected
Buzzer or lamp
b Remote Alarm Operations (p. 43)
A
A B Alarm Output for a Specified
Period Continuous Alarm Output
Detecting Intruders
Using an External
Sensor (p. 38)
B
Detecting Intruders
Using Motion
Detector Settings
(p. 40)
C
Detecting Intruders
Using Both an External
Sensor and Motion
Detector Settings (p. 42)
• The live image indicator can be
checked.
• The alarm output terminal at the
rear of the camera can be
checked.
The first alarm image generated when
the alarm was detected can be
transmitted via e-mail.
Check alarm
b Transmitting Alarm Images Via
E-mail (p. 48)
a Saving into the camera’s internal
memory (p. 45)
A Recording Post-alarm Images
Only
B Recording Both Pre-alarm and
Post-alarm Images
a Saving to an Expansion Memory
Card (p. 51)
PC card
(CompactFlash card)
Internal memory:
Approx. 16 MB
L5AM2/XE (VCC-WB4000P) GB 2004, 2, 17
English – 35 –