Sanyo VCC-WB4000P User Manual
Page 39
Alarm Settings
Detecting Intruders
A Detecting Intruders Using an
External Sensor
When a device such as an infrared sensor is
installed to a place such as a door, intruders can
be detected by the opening and closing of the
door. When an alarm is detected, an alarm
buzzer can be made to sound and the ALARM
indicator on the live image screen can be made
to illuminate.
1
Connect a device such as an infrared
sensor to the ALARM IN terminal at the
rear of the camera. (p. 10)
2
Set “ALARM REC USE” to “NO USE” and
then click the [SET] button.
Set to “NO USE” first so that alarms cannot
be detected while you are making the
settings. Change the setting back to “USE”
after you have finished making the settings.
3
Set “EXTERNAL ALARM” to “NO”
(example).
Available settings:
•
OFF: No external alarm input is detected.
•
NC: Normal close (normally closed, but
input is detected when open).
•
NO: Normal open (normally open, but
input is detected when closed).
Note: When “NC” or “NO” is selected, you
can then also change the “ALARM
SOUND MODE”, “ALARM
BUFFERING” and “ALARM
DURATION” settings.
4
Set “ALARM OUT” to “NO” (example).
Available settings:
•
OFF: No external alarm input is detected.
•
NC: Normal close (normally closed, but
input is detected when open).
•
NO: Normal open (normally open, but
input is detected when closed).
Note: If “ALARM OUT” has been set to “NO”
or “NC” for the COLOR mode or
TIMER mode DAY/NIGHT settings
and an IR lamp has been connected,
then the buzzer will not sound. (p. 32,
34)
5
Set “ALARM OUT MODE” to “ALARM
OUT”.
6
Set “ALARM OUT TIME” to “60 sec.”.
Available settings:
2, 5, 10, 15, 20, 30, 60 sec.,
2, 3, 4, 5 min., REMOTE
(The “REMOTE” setting only appears
when “ALARM OUT MODE” is set to
“REMOTE CONTROL”.)
2
3
4
5
6
L5AM2/XE (VCC-WB4000P) GB 2004, 2, 17
– 38 –
English