Siemens SpeedStream 6500 Series - Manual (Page 10)

6500 Series Residential Gateway User’s Guide Introduction
Rear Panel
DSL Port
(RJ11) Connect the RJ11 DSL cable (looks like a telephone
cord) here to use your DSL connection through an
existing phone line.
USB Port If your Gateway has a USB port, connect the USB
cable here. The USB driver software must be
installed from the provided CD-ROM.
10/100 Ethernet
Ports 1 - 4 Connect the RJ45 Ethernet cable here to connect
your computers, hubs, or switches to the Gateway.
If your model has four ports, you can configure port
#4 as either a LAN or WAN port.
Power Adapter
Port Connect the supplied power adapter provided with
the Gateway here.
Power Button Push this button to power the Gateway on and off.
Example Rear Panel
General Safety Guidelines
When using the SpeedStream Gateway, observe the following safety guidelines:
• Never install telephone wiring during a storm.
• Avoid using a telephone during an electrical storm. Lightening increases the risk of electrical shock.
• Do not install telephone jacks in wet locations and never use the product near water.
• Do not exceed the maximum power load ratings for the product; otherwise, you risk dangerous
overloading of the power circuit.
5