Sundance Spas 880 - Manual (Page 67)

Page 61
880 SERIES
7. Adjusting Treble Level
Press EQ button (5) repeatedly until display reads “TRE.” Press VOL
up/down button (3) to choose desired setting. A display of “TRE 0”
indicates center, -1 to -7 indicates treble cut, +1 to +7 indicates treble
boost.
Note: Unit returns to volume mode if volume control is not operated for 3
seconds.
8. Adjusting Balance Level
Press EQ button (5) repeatedly until display reads “BAL.” Press VOL
up/down button (3) to choose desired setting. A display of “BAL R-L”
indicates center, L1 to 15 indicates left balance, R1 to 15 indicates
right balance.
Note: Unit returns to volume mode if volume control is not operated for 3
seconds.
9. Adjusting Fader Level
Press EQ button (5) repeatedly until display reads “FAD.” Press VOL
up/down button (3) to choose desired setting. A display of “FAD F-R”
indicates center, R1 to 15 indicates rear fade, F1 to 15 indicates front
fade.
Note: Unit returns to volume mode if volume control is not operated for 3
seconds.
10. Adjusting Beep Level
Press and hold down EQ button (5) for about 2 seconds until display
reads “BEEP 2ND”, then release. Press VOL up/down button (3) to
select either Beep 2ND or Beep on option.
Note: Unit returns to volume mode if volume control is not operated for 3
seconds.
11. Adjusting I-VOL Level
Press and hold the EQ button (5) for about 2 seconds, then
repeatedly press until display reads “I-VOL” (Initial Volume Level
Adjustment). Press VOL up/down button (3) to choose desired
setting (0 to 45), then press ENT button (9) to confirm. This feature
regulates the max volume level during power up.
Note: Unit returns to volume mode if volume control is not operated for 3
seconds.
12. Adjusting Area
In FM2 band, press and hold the EQ button (5) for about 2 seconds,
then repeatedly press until display reads “USA” or “EUR”. Press