Sundance Spas 880 - Manual (Page 58)

Page 52
880 SERIES
PROBLEM PROCEDURE
Pump does not
operate and icon
does Depress JETS Button.
1. If no sound is detected or if a buzzing sound
is detected, turn off power to the spa and
contact your authorized dealer or qualified
service technician.
2. If motor operates, but now water flows to jets:
a. Pump may not be properly primed. See
instructions below.
b. Contact your Sundance Spas dealer or
qualified service technician.
Pump Priming Instructions:
This method must be used for the jets pumps because these pumps
are not connected to the main filter system in any way.
1. Turn off the power to the spa.
2. Remove the handle from the massage selector supplied by the pump
you are priming.
3. Loosen the massage selector’s cap slightly (counterclockwise),
listening for the air to seep out.
4. Tighten the cap finger tight, replace the handle, and turn the spa’s
power back on.
CAUTION: If freezing conditions exist and pump is not
operational, take measures to protect the system from freeze
damage. See Section titled “Winterizing”, page 46.
PROBLEM PROCEDURE
Poor jet acton
(See Figures
F-H, pages
23-25) 1. Make certain the jets pump is turned on.
2. Check position of massage selectors.
3. Open air control for selected jet system.
4. Check for adequate water level.
5. Check for dirty filter (pages 42-44).
Water is too hot 1. Reduce thermostat setting (page 21).
2. Switch hot tub to “Economy” mode to turn
heater on only during programmed filter cycles
(page 37).