Sundance Spas 880 - Manual (Page 43)

Page 37
880 SERIES
11.0 Heating Modes
The control system in your hot tub activates a programmable “Standard”
or “Economy” mode which effects when the heater operates. Refer to
Sections 11.1 and 11.2 below for additional information.
11.1 Standard Mode (Factory Default)
Standard mode is typically selected by customers in cold climates where
heat up times are extended due to lower ambient temperatures. In this
mode, water temperature is regulated by the set temperature which
activates the heater automatically as needed.
11.2 Economy Mode
Economy mode is typically selected by customers in warm climates
where heat up times are minimized due to higher ambient temperatures.
In this mode, the water temperature is regulated by the set temperature
only when a programmed filter cycle is running.
11.3 Selecting Standard or Economy Mode
Press the (MODE)
button to select either “Standard” or “Economy”
mode. The control panel’s indicator on the right side of the LCD changes
to indicate which mode is selected.
Note: “Standard” is shown when Standard Mode is selected. No display
is shown when economy mode is selected.
11.4 Clean-Up “Blow-Out” Cycle
The clean-up cycle is once per day in both Standard and Economy
modes at 12:00 (noon) for two minutes. This is not user programmable.
• Maxxus Models: Jets pump 3 and blower activate for
approximately 45 seconds to circulate any water in the plumbing.
Pump 3 shuts off, then pump 2 and the blower activate for
approximately 45 seconds, then shut off. Finally, pump 1
activates and runs for approximately 30 seconds, then shuts off.
• Cameo/Optima Models: Jets pump 2 and blower activate for one
minute to circulate any water in the plumbing. After 1 minute,
pump 2 and blower shut off and jets pump 1 activates for 1
minute, then shuts off.