beautypg.com

Sundance Spas 880 User Manual

Page 49

background image

Page 43

880 SERIES

Filter Cleaning/Replacement Procedure

2

1

3

Filter Cleaning Requirements:
• Clean MicroClean Ultra

TM

Pleated Filter (1) monthly

and replace every 18 months (6473-165).

• Rinse off MicroClean Ultra™ Insert (2) monthly and

replace every 6 months or as needed (6473-164).

Filter Removal Instructions:
Loosen filter nut to provide clearance, then remove
MicroClean™ Ultra Filter Assembly from spa.

Filter Nut

1

2

1

2

Top

1

2*

Monthly Filter Cleaning Procedure

We recommend cleaning the outer pleated filter (1) with a high pressure water nozzle and the

filter insert (2) with a low-pressure water nozzle monthly. Periodically, the outer pleated filter

cartridge (1) will require a more thorough cleaning to remove embedded oils and minerals by

using special spa filter cleaners offered by your spa dealer. Always remove the center filter

insert (2) before cleaning the outer filter (1) with chemicals. Never use filter cleaners of

any kind on the filter insert (2) or it may be damaged.

Procedure:
1. Grasp center filter insert end cap (2) in hand and pull

outward from pleated cartridge (1). If filter insert (2) is

6 months old, throw it away and purchase new one.

DO NOT install new insert at this time.

2. Rinse debris from all outer filter (1) pleats using a

garden hose and high-pressure nozzle. Repeat

process until all filter pleats are clean. Then rinse

debris from inside of filter (1). If chemical cleaners

are used, follow manufacturers instructions.

Lightly rise filter insert (2) and place in clean location. *DO NOT use chemical cleaners or high-

pressure nozzle on insert (2) or it may be damaged!

3. Install filter insert (2) into outer pleated filter (1) by gently sliding inward until a slight resistance

is felt approximately 1/4” from bottom. Lightly tap insert end with palm of hand to “snap” in place.

Insert is properly installed when end cap rests “flush” against outer filter end cap.

4. Install Filter assembly back into spa by performing step 2 in reverse order. Tighten filter nut so it

just touches the filter face. DO NOT OVERTIGHTEN!

5. Turn power to spa back on.

TURN POWER TO SPA OFF! NEVER OPERATE SPA WHEN FILTER IS
NOT PROPERLY INSTALLED OR IF WEIR ASSEMBLY IS DAMAGED
OR ALTERED!

Replacement filter cartridges may be purchased from your Sundance

Spas dealer.