Sundance Spas 880 - Manual (Page 23)

Page 17
880 SERIES
4. Activate Jets Pumps
Turn on all jet(s) pumps and blower to ensure proper
mixing when adding start up chemical in step 5.
5. Add Start-Up Chemicals
Add the hot tub water chemicals as recommended by your Sundance
Spas dealer. See Section titled “Water Quality Maintenance” (page
47) for general guidance.
6. Establish A Stable Sanitizer Reading
Establish a stable sanitizer reading between 3.0-4.0 ppm chlorine
or 2.0-4.0 ppm bromine. To ensure healthy water conditions, always
maintain a constant sanitizer reading within the levels recommended
by the Association of Pool And Spa Professionals printed on the
inside cover of this manual. If sanitizer levels cannot be stabilized,
perform the decontamination procedure steps 9-15 on the following
page.
Note: The “decontamination procedure” steps 9-15 should also be used
after the hot tub has been “Winterized” (Section 13.7) or has been sitting
without power for an extended period.
7. Set Hot Tub To Heat
To warm hot tub water to a comfortable temperature, follow
these steps:
•
The LCD display on the control panel displays the
actual temperature of the hot tub water. Press either the
COOLER (Down) or WARMER (Up) button once to display the
“set” temperature for 5 seconds. If you want the water to heat
to a different temperature, simply press COOLER or WARMER
within 5 seconds. The set temperature increases or decreases
by one degree each time either button is pressed.
• The heater will turn off when the temperature corresponding to
the thermostat setting is achieved.