Sundance Spas 880 - Manual (Page 48)

Page 42
880 SERIES
13.0 Hot Tub Maintenance
Proper and regular maintenance of your hot tub will
help it retain its beauty and performance. Your authorized Sundance
Spas dealer can supply you with all the information, supplies, and
accessory products you will need to accomplish this.
WARNING: Risk of Injury. The suction fittings in this spa
are sized to match the specific water flow created by the
pump. If it is necessary to replace the suction fittings or
the pump, be sure that the flow rates are compatible.
Because of the risk of injury,
Never operate or use the spa if the filter, filter lid,
or skimmer assembly are broken or any part of the
skimmer assembly is missing. Please contact your
dealer or nearest service center for service.
Never replace a suction fitting with one rated less than
the flow rate marked on the original suction fitting.
•
•
13.1 Cleaning/Replacing the Filter Cartridge
A programmable “Change Filter” reminder icon flashes on the
control panel display after a specified number days to remind you
to perform routine maintenance on your filter system. This reminder
must be reset at each interval. Refer to Section 12.6 (page 41) for
additional information and programming details.
Your Sundance hot tub is equipped with a two-stage MicroClean Ultra
filter cartridge assembly under the filter lid (Figures F through H, pages
23-25). Debris is filtered by the filter/circulation pump drawing water
through the filter assembly 24 hours a day, 7 days a week (unless
programmed otherwise). To ensure optimum performance, clean the
outer pleated filter and center insert monthly. Then replace the center
insert every 6 months, or as needed thereafter. Refer to procedure below
for details.
All models include a suction cover filter (#6540-213) located
directly under the MicroClean Ultra filter cartridge assembly that
prevents debris from entering the hot tub plumbing when jets
pump 1 is running. This filter should be cleaned every 2 months.
ALWAYS TURN POWER TO THE HOT TUB OFF BEFORE REMOVING
THE MICROCLEAN ULTRA FILTER ASSEMBLY!