Siemens Simantic Net NCM for Industrial Ethernet S7 User Manual
Page 22
Communication via Ethernet CPs in S7 Stations
22
SIMATIC NET NCM S7 for Industrial Ethernet
C79000-G8976-C129–06
1.3.2
OP Operation: Connecting Operator Interface Devices via
Industrial Ethernet
Requirements
Operation allowing operator interface functions is possible when the following
conditions are met:
S
The operator interface device has:
– an Ethernet CP installed
– SOFTNET S7 for Ind. Ethernet or S7-1613/ WIN 95, WIN NT, MS-DOS,
Windows installed.
S
The CPs in the S7 stations are supplied with a MAC/IP address (use the default
MAC address or set an IP address).
Procedure
To be able to use S7 communication, address the required module in the SIMATIC
S7 PLC on your operator interface system.
For more detailed information, refer to the description of your operator interface
system.