Siemens Gigaset SL565 - Manual (Page 7)

6
First steps
Gigaset SL565 / GBR PTT / A31008-M1715-L111-2-7619 / starting.fm / 11.7.07
Reception strength:
The display shows the quality of the radio
contact between the base station and
handset:
u Good to poor: Ð i С Т,
u No reception: | flashes.
Connecting the base station
¤
First connect the mains adapter and
then the phone jack as shown below-
and place the cables in the cable
recesses.
1 Back of the base station (detailed view)
2 Mains adapter 230 V
3 Phone jack with phone cord
Please note:
u The mains adapter must be always
connected, as the phone will not oper-
ate without mains connection.
u If you buy a replacement phone cord
from a store, ensure that the phone
jack is connected correctly.
Setting up the handset for use
The display is protected by
a plastic film. Please
remove the protective
film!
Fitting the battery pack
¤
Insert the battery pack at an angle from
the right introducing the lugs into the
cavity first.
¤
Then push the casing from the top,
until the retaining clip on the side of
the battery pack clicks securely into
place in the casing.
Please note:
You must press the retaining clips down in
order to remove the battery pack.
Correct phone jack assignment
1 unused
2 unused
3 a
4 b
5 unused
6 unused
1
3
2
1
1 1
3
2
1
4
5
6
Caution:
Use only the rechargeable Siemens Original
battery pack (page 58). Never use a conven-
tional (non-rechargeable) battery pack, as this
may cause significant damage to health and
property. For example, the outer casing of the
battery pack could be destroyed or the battery
pack could explode. The phone could also mal-
function or be damaged as a result of using
batteries that are not of the recommended
type.