Siemens Gigaset SL565 - Manual (Page 57)

56
Appendix
Gigaset SL565 / GBR PTT / A31008-M1715-L111-2-7619 / appendix.fm / 11.7.07
Appendix
Care
Wipe the base station, charging cradle and
handset with a damp cloth (do not use
solvent) or an antistatic cloth.
Never use a dry cloth. This can cause
static.
Contact with liquid
If the handset has come into contact with
liquid:
1. Switch off the handset and remove
the battery pack immediately.
2. Allow the liquid to drain from the hand-
set.
3. Pat all parts dry, then place the handset
with the battery compartment open
and the keypad facing down in a dry,
warm place for at least 72 hours (not
in a microwave, oven etc.).
4. Do not switch on the handset again
until it is completely dry.
When it has fully dried out, you will nor-
mally be able to use it again.
Questions and answers
If you have any queries about the use of
your telephone, you can contact us at any
time at
www.siemens.com/gigasetcustomercare .
The table below contains a list of common
problems and possible solutions.
!
The display is blank.
1. The handset is not switched on.
¥
Press and hold the end call key a .
2. The battery pack is flat.
¥
Charge/replace the battery pack
(page 8).
The handset does not respond to a key press.
The keypad lock is activated.
¥
Press and hold the hash key
#
(page 14).
"Base station x" is flashing in the display.
1. The handset is outside the range of the base
station.
¥
Reduce the distance between handset/
base station.
The base station's range is reduced because
eco mode is activated.
¥
Deactivate eco mode (page 16) or
reduce the distance between the hand-
set and the base station.
2. The handset has been de-registered.
¥
Register the handset (page 40).
3. The base station is not switched on.
¥
Check the base station mains adapter
(page 6).
Base Search is flashing in the display.
The handset is set for
Best Base and no base sta-
tion is switched on or within range.
¥
Reduce the distance between handset/base
station.
¥
Check the base station mains adapter
(page 6).
Handset does not ring.
1. The ringtone is switched off.
¥
Activate the ringtone (page 46).
2. Call diversion set to All Calls .
¥
Switch off Call Diversion (page 17).