Siemens 11 User Manual

Page 11

Installing the Gigaset USB Adapter 11

Gigaset USB Adapter 11 / en / A31008-E105-B102-1-7619 / installation.fm / 06.12.2002

6. After the software installation is finished, plug the Gigaset USB Adapter 11 into the

USB port of your computer.

7. Upon hardware detection, Windows OS will install the driver for the card automati-

cally.

Note:

◆

If you are prompted with the "INF not found" alarm, please click the Browse button

to locate the .inf file. Usually it is located on C:\Windows\inf or C:\Winnt\inf.

◆

For Windows 2000: If you are prompted with the Digital Signature not Found alarm

message, just click Yes to ignore it and continue with the auto-installation.

◆

For Windows 98 SE: If prompted, you need to insert your Windows 98 SE installation

CD to complete the driver installation.

Now you are done with the installation procedure. If the Wireless LAN Monitor Utility

does not start automatically, select Start - Programs - Wireless LAN Client Utility -

Wireless LAN Monitor Utility. You should be able to see the Wireless LAN Monitor

icon appearing on the right side of the taskbar. Proceed to following chapter to config-

ure or fine-tune your Gigaset USB Adapter 11 settings.

The red LED on the Gigaset USB Adapter 11 will light when the Gigaset

USB Adapter 11 is connected to your computer.

If you need to set up the TCP/IP address or the subnet mask, refer to "Set-