Siemens Gigaset 4015 - Manual (Page 63)

59
Appendix
Gigaset 4015 Classic, GBR, A31008-G4015-B101-1-7619 anha.fm 17.09.01
Appendix
Maintenance
Simply wipe the base station and handset with a damp cloth or an
antistatic wipe. Never use a dry cloth as this can cause static
discharge!
Troubleshooting
If your telephone does not behave the way you want it to, first try to
solve the problem using the following list.
Fault Possible cause Solution
No
display. Handset not
activated Hold down the end call
key for 1 second
Batteries empty Charge or replace the
batteries (see page 7).
No reaction to
keystroke. Keypad protection
activated Hold down the
4
key
for 1 second
No radio connec-
tion to the base
station – all
displays flashing. Handset outside the
base station range. Move closer to the base
station.
Handset not
registered Register the handset
(see page 41).
Base station not
activated Check the connector at
the base station (see
page 6).
Handset that is in
the base station is
not charging. Line seized by a
second handset for a
long period. Maximum charging pow-
er is only possible while
nobody
is making calls.
Handset/base sta-
tion does not ring. Ringer off Activate the ringer
(see page 51/page 54).
Your caller on the
telephone cannot
hear you. The key was
pressed – the micro-
phone is “muted”
.
Press to
re-activate the micro-
phone.
The incoming call
number is not
displayed al-
though CLIP is set. The telephone
number transmis-
sion
is blocked. Callers must permit the
transmission of their tele-
phone numbers at their
network providers.
INT GO BACK OK