beautypg.com

0 saving and starting a new track, 1 other settings in track menu, 1 using the trip log – Standard Horizon CP500 User Manual

Page 54: Track menu, Trip log

background image

Page 56

CP500

Figure 10.0 - Tracking

10.0.0 Saving and starting a new Track

A Track is automatically saved to memory. To start a new Track:
1. Press [MENU]. Move the ShuttlePoint knob to highlight USER POINTS and press

[ENT].

2. Move the ShuttlePoint knob to highlight TRACK and press [ENT].
3. Move the ShuttlePoint knob to highlight ACTIVE TRACK and press [ENT] or move the

ShuttlePoint knob to the right.

4. Move the ShuttlePoint knob up/down to select the next available open Track and press

[ENT] or move the ShuttlePoint knob to the right.

5. Move the ShuttlePoint knob to highlight TRACKING and press [ENT]. Move the

ShuttlePoint knob to set On and press [ENT].

6. Press [CLR] or move the ShuttlePoint knob to the left until the Chart page is shown.
7. A new Track now will be laid down.

10.0.1 Other Settings in Track Menu

You will notice the Track menu has other selections:

TRACKING

Allows turning on or off the tracking function

ACTIVE TRACK

This selection allows you to save a Track to one of the 5 Tracks available

VISIBLE

Shows or hides a Track shown in ACTIVE TRACK menu

LINE COLOR

Selects the color of the Track line

DELETE

Deletes a Track selected in the ACTIVE TRACK menu

STEP UNIT

Allowable selection are Distance or Time

DISTANCE

Setup the Distance interval the Track point is placed on the Chart page

TIME

Setup the TIME interval the Track point is placed on the Chart page

10.1 USING THE TRIP LOG

On the Chart, Navigation, Highway and NMEA Data pages the windows may be customized
to show TRIP LOG information.
1. Select one of the pages listed above, press and hold [MENU]. You will notice one of the

data boxes will be highlighted.

2. Press [ENT] and move the ShuttlePoint knob to highlight TRIP LOG, press [ENT].
3. A popup window will be shown with Nm (Nautical Mile), Sm (Statute Mile), Km

(Kilometer) and RESET. Move the ShuttlePoint knob to select the desired units of
measure and press [ENT].