beautypg.com

1 editing a mark, Mark, Mark creation – Standard Horizon CP500 User Manual

Page 41: Route, Waypoint, Creating marks, Editing a mark

background image

CP500

Page 43

7. CREATING MARKS

Definitions:
MARK
Can be a stand alone position or be linked to a Route. A Mark is place on the Chart page using
[MARK] or by entering in information in the MARK/WAYPONTS List NEW MARK selection.
WAYPOINTS
Always linked to a Route. Are placed on the Chart page using [ROUTE].

NOTE

The difference between a Mark and a Waypoint is
a. When a Route is created using WAYPOINTS and the ROUTE is deleted the WAYPOINTs are

also deleted.

b. If a Route is created using MARKS and the ROUTE is deleted the MARKs remain.

7.0

CREATING A NEW MARK USING THE CHART PAGE

1. Move the ShuttlePoint knob to the desired or approx. Lat/Lon and press [MARK].
2. You will notice a Mark is placed under the location of the Cursor and a popup window

is shown with the exact Lat/Lon of the Mark.

3. If the position is incorrect press [ENT], select EDIT using the ShuttlePoint knob and

press [ENT]. Press [E

DIT

] allows changing of the position, Mark name, icon type and

color of the icon.

Figure 7.0 - Mark creation

NOTE

After entering in all the Marks it is a good practice to back up the points to a C-MAP User C-CARD.
Refer to Section 11.

7.1

EDITING A MARK

If a Mark has previously been created and you wish to Edit it, move Cursor over the top of
the Mark.

Figure 7.1 - Mark editing