beautypg.com

Table d-1 – Sun Microsystems Ethernet PCI-X Adapter User Manual

Page 74

background image

58

Sun 10-Gigabit Ethernet PCI-X Adapter Installation and User’s Guide • December 2005

TABLE D-1

lists the tunable

ixge

driver parameters for Linux operating systems, and

describes their function.

TABLE D-1

Tunable

ixge

Driver Parameters for Linux Operating Systems

Keyword

Description

FlowControl

Valid Range: 0-3 (0=none, 1=Rx only, 2=Tx only, 3=Rx&Tx)
Default: Read from the EEPROM
If EEPROM is not detected, default is 3.
This parameter controls the automatic generation (Tx) and response
(Rx) to Ethernet PAUSE frames.

RxDescriptiors

Valid Range: 64-4096
Default Value: 1024
This value is the number of receive descriptors allocated by the driver.
Increasing this value allows the driver to buffer more incoming packets.
Each descriptor is 16 bytes. A receive buffer is also allocated for each
descriptor and can be either 2048, 4056, 8192, or 16384 bytes, depending
on the MTU setting. When the MTU size is 1500 or less, the receive
buffer size is 2048 bytes. When the MTU is greater than 1500 the receive
buffer size will be either 4056, 8192, or 16384 bytes. The maximum MTU
size is 16114.

RxIntDelay

Valid Range: 0-65535 (0=off)
Default Value: 72
This value delays the generation of receive interrupts in units of 0.8192
microseconds. Receive interrupt reduction can improve CPU efficiency
if properly tuned for specific network traffic. Increasing this value adds
extra latency to frame reception and can end up decreasing the
throughput of TCP traffic. If the system is reporting dropped receives,
this value may be set too high, causing the driver to run out of available
receive descriptors.

TxDescriptors

Valid Range: 64-4096
Default Value: 256
This value is the number of transmit descriptors allocated by the driver.
Increasing this value allows the driver to queue more transmits. Each
descriptor is 16 bytes.

XsumRX

Valid Range: 0-1
Default Value: 1
A value of 1 indicates that the driver should enable IP checksum offload
for received packets (both UDP and TCP) to the adapter hardware.