Sun Microsystems Ethernet PCI-X Adapter - Manual (Page 26)

10 Sun 10-Gigabit Ethernet PCI-X Adapter Installation and User’s Guide • December 2005
4. View the .properties file for a list of device properties.
The . properties command displays the specific information about the installed
adapter. If you are using the Sun 10-Gigabit Ethernet adapter, your output will be
similar to the following:
5. Type the following when you finish looking at the .properties values:
Rebooting the System
After verifying the adapter installation, use the boot -r command to perform a
reconfiguration boot on your system.
ok cd /pci@9,600000/ethernet@1
ok .properties
assigned-addresses 83000810 00000000 00100000 00000000 00008000
81000820 00000000 00000300 00000000 00000020
reg 00000800 00000000 00000000 00000000 00000000
03000810 00000000 00000000 00000000 00008000
01000820 00000000 00000000 00000000 00000020
compatible 70 63 69 38 30 38 36 2c 31 30 34 38 2e 38 30 38
name ethernet
66mhz-capable
devsel-speed 00000001
class-code 00020000
interrupts 00000001
latency-timer 00000040
cache-line-size 00000010
max-latency 00000000
min-grant 000000ff
subsystem-id 00007036
subsystem-vendor-id 0000108e
revision-id 00000002
device-id 00001048
vendor-id 00008086
ok
ok device-end
ok boot -r