Siemens Gigaset SL100 - Manual (Page 77)

76
Appendix
Gigaset SL100 colour / IM_eng / A31008-M1571-R221-2-7619 / appendix.fm / 04.11.05
Appendix
Care
Wipe the base station and handset with a damp cloth (do not use solvents) or an anti-
static cloth. Never use a dry cloth. This can cause static.
Contact with liquid
If the handset should come into contact with liquid, on no account switch the device
on. Remove the battery immediately.
Allow the liquid to drain out of the device, and then pat all parts of the device dry.
Keep the handset with the battery removed in a warm, dry place for at least 72 hours.
In many cases, you will then be able to use it again.
Questions and Answers
If you have any questions about the use of your phone, you can contact us 24/7 at
www.siemens.com/gigasetcustomercare. You will find the most frequently asked
questions and answers below.
!
What has happened if … Possible cause Possible solution
… the display is blank? The handset is not switched on.
The battery is flat.
Press the "end call" key
a
for
about 2 sec.
Charge or replace the battery
(page 8).
… the handset fails to respond
to a key press?
The keypad lock is activated. Press the hash key
R
for
about 2 sec. to deactivate the
lock (page 10).
… "Base station x" flashes in
the display?
The handset is outside the range
of the base station.
The base station is not switched
on.
Move the handset nearer to the
base station.
Check the power connector at
the base station (page 7).
… Base Search flashes in the
display?
The handset is set for Best
Base . But no base station has
been activated or in range.
Move the handset nearer to the
base station.
Check the power connector at
the base station (page 7).
… the handset does not ring? The ringer is switched off. Activate/deactivate the ringer
(page 68).
… I cannot hear a ringer tone/
dial tone?
You have changed the telephone
cord on your Gigaset.
When purchasing a new cord
ensure that it has the correct
pin connections (page 7).
… the other party cannot hear
me?
You have pressed the u (INT)
key. This mutes the handset.
Switch on the microphone
again (page 18).
… the incoming call number is
not displayed even though
CLIP is set?
Calling line identification is not
enabled.
The caller should ask his net-
work provider to enable the
identification of his number
(CLI).
… I hear an error tone (falling
tone sequence) when keying
an input?
The action has failed or the input
is incorrect.
Repeat the procedure; watch
the display and if necessary
refer to the operating instruc-
tions.
… I cannot listen to the net-
work mailbox?
Your phone system is set for
pulse dialling.
Set your phone system to tone
dialling (page 75).