Siemens Gigaset SL100 - Manual (Page 76)

75
Connecting the base station to a PABX
Gigaset SL100 colour / IM_eng / A31008-M1571-R221-2-7619 / pabx.fm / 04.11.05
◆ If you use the telephone number from the directory when sending an SMS, you have
to delete the access code.
◆ You can delete an access code using X . To insert a pause, press ,
s Insert Pause or , s Insert Recall .
Setting pauses
Changing the pause after line seizure
You can set the length of the pause that is inserted between pressing the top half of the
c key and the transmission of the telephone number (the factory setting is 3 seconds).
Change pause after Recall key
You can change the length of the pause if your PABX requires this (refer to the operating
instructions for your PABX; the factory setting is 800 ms).
Changing the dialling pause (pause after access code)
Precondition: You have stored an access code (page 74). Factory setting: 3 seconds.
Switching temporarily to tone dialling (DTMF)
If your PABX still operates with dial pulsing (DP) but tone dialling (DTMF) is required for
a particular call (e.g. to check your network mailbox), you have to switch to tone dialling
during the call.
Precondition: A call is in progress.
à
OK à OK
v Open the menu.
N O 1 L
Press keys.
~
Enter a number for the length of the pause
(1 = 1 sec.; 2 = 3 sec.; 3 = 7 sec. and confirm.
OK
v
Open the menu.
N O 1 2
Press keys.
~
Enter a number for the length of the pause (1 =
800 ms; 2 = 1600 ms; 3 = 3200 ms) and confirm.
OK
v
Open the menu.
N O 1 1
Press keys.
~
Enter a number for the length of the pause (1 =
1 sec.; 2 = 2 sec.; 3 = 3 sec.; 4 = 6 sec.) and confirm.
OK
v
Open the menu.
s
Tone Dialing
Tone dialling is now activated for this call. OK