JVC DLA-G150CLE - Manual (Page 31)

DLA-G150CLU DLA-G150CLE
1-31
No.51931
61
Replacing the Light-Source Lamp
ENGLISH
DEUTSH
FRAN
ÇAIS
ITALIANO
ESPAÑOL
3 Insert the new light-source lamp fully
inside and fasten the screws.
Fasten the two screws with a flat-end screwdriver.
CAUTION
• Do not touch the glass surface of the light-source lamp
directly with your hand as well as staining it. If you touch
with a bare hand, oils and other substances on your hand
may adhere to the lamp, possibly preventing it from
performing as specified and therefore giving a shortened
lamp life, a darkened screen, etc. To handle a new light-
source lamp, hold it by the plastic part. Never touch the
metal part or the front glass surface.
4 Replace the lamp-replacement opening
cover and fasten the screws.
Fasten the two screws with a flat-end screwdriver.
CAUTIONS
• Install the light-source lamp and close the lamp-
replacement opening cover correctly; otherwise, a safety
switch is activated to prevent the projector from operating.
• If the claw on the lamp-replacement opening cover is
damaged, the projector may not possibly operate. Then,
replace with a new lamp-replacement opening cover.
5 Reset the lamp use time.
Perform “Resetting the Lamp Use Time” on page 62.
Screw
Light-source lamp
Handle
Lamp-replacement
opening cover
Be careful not to
damage the claw.
60
Replacing the Light-Source Lamp
■ Be sure that the power cord is unplugged from the wall outlet.
1 Remove the lamp-replacement opening
cover by loosening screws.
Loosen the two screws with a flat-end screwdriver.
Note
• The screws are fitted so that they do not come off the lamp-
replacement opening cover.
2 Loosen the screws, raise the handle,
and pull out the light-source lamp.
Loosen the two screws with a flat-end screwdriver.
Note
• The screws are fitted so that they do not come off the light-
source lamp.
(To be continued on the next page)
Screw
Lamp-replacement
opening cover
Be careful not to damage
the claw.
Screw
Light-source lamp
Handle