JVC GY-HM700U - Manual (Page 115)

111
[PHONES] Terminal
Audio output from the [PHONES] terminal can be selected
using [Audio Monitor] in the [A/V Out] menu (
A Page 87) as
well as the [MONITOR SELECT] switch on the camera
recorder.
The different combinations of settings that are output from
the [PHONES] terminal and monitor speaker are as follows.
Connecting an external device to the IEEE1394 terminal
enables you to perform the following.
A Backup recording ( A Page 113)
The images recorded on the SDHC card in the camera
recorder can be backed up.
B Stream transmission to a non-linear editing system
(
A Page 114)
Playback images on the camera recorder can be stream
output during editing using a non-linear editing system.
Note :
● When connecting the camera recorder to an external device
using an IEEE1394 cable, make sure to observe the
following. Improper connection may cause the circuit of the
connected unit to malfunction.
● Turn off the power of the camera recorder and
connected devices before connecting the IEEE1394
cable.
● Do not connect the cable in an environment where
static electricity occurs or is likely to occur.
● Make sure that each camera recorder is connected to
only one external device at any one time.
● Turn off the power of the camera recorder and
connected devices before switching the [HD/DV]
IEEE1394 terminal mode switch.
● A message indicating AVIDEO FORMAT INCORRECTB
appears if the format of the input/output video signals from
the [IEEE1394] input terminal is different from the [HD/DV]
IEEE1394 terminal mode switch setting. Adjust the [HD/DV]
IEEE394 terminal mode switch according to the video
format.
[MONITOR SELECT]
Switch Settings
[Audio Monitor]
Settings
[PHONES] Terminal
L R
[CH-1] ^ CH1
[BOTH] [Mix] CH1+CH2
[Stereo] CH1 CH2
[CH-2] ^ CH2
IEEE1394 Connection
[HD/DV] IEEE 1394
Terminal Mode
Switch
[IEEE1394] Terminal
VIDEO FORMAT
INCORRECT