JVC LVT1112-001A - Manual (Page 21)

17
Speaker settings
When selecting “MEDIUM ROOM,”
• Center speaker delay time
is set to 1 msec.
• Surround speakers delay time
is set to 2 msec.
ANALOG
SUBWFR
VOL
L R
SUBWFR FRNT SP
LFE
DIGITAL IN AUTO SR MODE
QUICK SETUP (Back to the beginning)
CNTR SP
SURR DL
CROSS
CNTR DL
D.COMP
SURR SP
3
Turn MULTI JOG to select the appropriate setting
for the item selected in step
2, then press SET.
Your setting is stored.
Ex.: When selecting “NO” for “SUBWFR.”
4 If you would like to set other items, repeat steps
2 and 3.
Setting the subwoofer information
— SUBWFR (subwoofer)
Register whether you have connected a subwoofer or not.
YES*: Select when you have connected a subwoofer.
The subwoofer speaker indicator (
SUBWFR ) lights up
on the display (see page 14). You can adjust the
subwoofer output level (see page 21).
NO: Select when you have not connected or have
disconnected a subwoofer.
* Initial setting
Setting the speakers size
— FRNT SP (front speakers), CNTR SP (center
speaker), SURR SP (surround speakers)
Register the sizes of all the connected speakers.
LRG (large): Select when the cone speaker size is larger than
12 cm.
SML (small)*: Select when the cone speaker size is smaller than
12 cm.
NO: Select when you have not connected a speaker. (Not
selectable for the front speakers.)
* Initial setting
NOTES
• If you have selected “SML (small)” for the front speaker size, you
cannot select “LRG (large)” for the center and surround speaker
sizes.
• If you have selected “NO” for the subwoofer setting (see above and
page 16), you can only select “LRG (large)” for the front speaker
size.
ANALOG
VOL
L R
2.7 m
C
2.4 m
2.1 m
L R
LS
RS
When selecting “LARGE ROOM,”
• Center speaker delay time
is set to 0 msec.
• Surround speakers delay time
is set to 0 msec.
C
L R
LS
RS
3.0 m
Setting the speakers and subwoofer
information manually—Manual Setup
You can set the following speakers and subwoofer information
manually as you prefer. When you change your speakers, register the
information again.
• Subwoofer information—SUBWFR
• Speaker size—FRNT SP, CNTR SP, SURR SP
• Speaker delay time—CNTR DL, SURR DL
• Crossover frequency—CROSS
• Low frequency effect attenuator—LFE
• Dynamic range compression—D.COMP
Operating procedure
On the front panel ONLY:
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step
1 again.
1
Press SETTING.
MULTI JOG now works for the setting operation.
2
Turn MULTI JOG until the setting item you want
to set appears on the display, then press SET.
• As you turn MULTI JOG, the indication changes as follows:
STANDBY / ON STANDBY
TV DIRECT SETTING ADJUST SURROUND
DVD MULTI DVD STB VR TV FM / AM
SET / TUNER PRESET SOURCE SELECTOR MASTER VOLUME
PHONES / MULTI JOG
CONTINUED ON THE NEXT PAGE
15-20_RX-ES9SL[B]f 03.6.27, 16:49 17