JVC LVT1112-001A - Manual (Page 20)

16
Setting the speakers and subwoofer
information quickly—Quick Setup
Entering the use of the subwoofer, the number of the speakers, and
your room size, the center and surround speakers’ delay time is
automatically calculated.
• When you change your speakers, register the information about the
speakers again.
• You can also set the crossover frequency, the low frequency effect
attenuator and the dynamic range compression manually (see page 18).
On the front panel ONLY:
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step
1 again.
1
Press SETTING.
MULTI JOG now works for the setting operation.
2 Turn MULTI JOG until “QUICK SETUP” appears
on the display.
• As you turn MULTI JOG, the indication changes as follows:
3
Press SET.
“ENTER THE NUMBER OF SPEAKERS” scrolls on the display.
• Once you have selected “QUICK SETUP,” previously adjusted
speaker setting is cleared.
4
Turn MULTI JOG to select the number of the
speakers you have connected.
• As you turn MULTI JOG, the indication changes as follows:
5 SPEAKERS*: Select when the front, center and surround
speakers are connected.
4 SPEAKERS: Select when the front and surround speakers
are connected.
3 SPEAKERS: Select when the front and center speakers
are connected.
* Initial setting
Each speaker size is registered appropriately according to the
number of the connected speakers. For details, see the list
“Speaker size according to the number of speakers” on the right.
5
Press SET.
“ENTER USE OF SUBWOOFER” scrolls on the display.
6 Turn MULTI JOG to select whether or not you
have connected a subwoofer.
• As you turn MULTI JOG, the indication changes as follows:
* Initial setting
7
Press SET.
“ENTER ROOM SIZE” scrolls on the display.
8 Turn MULTI JOG to select the room size.
• As you turn MULTI JOG, the indication changes as follows:
* Initial setting
The center and surround speakers’ delay time is registered
appropriately according to the room size. For details, see the list
STANDBY / ON STANDBY
TV DIRECT SETTING ADJUST SURROUND
DVD MULTI DVD STB VR TV FM / AM
SET / TUNER PRESET SOURCE SELECTOR MASTER VOLUME
PHONES / MULTI JOG
ANALOG
SUBWFR
VOL
L R
5 SPEAKERS* 3 SPEAKERS
4 SPEAKERS
ANALOG
SUBWFR
VOL
L R
USE * NO
ANALOG
SUBWFR
VOL
L R
SMALL* MEDIUM
LARGE
ANALOG
SUBWFR
VOL
L R
SUBWFR FRNT SP
LFE
DIGITAL IN AUTO SR MODE
QUICK SETUP (Back to the beginning)
CNTR SP
SURR DL
CROSS
CNTR DL
D.COMP
SURR SP
Speaker settings
“Speaker delay time according to room size” below.
9
Press SET to finish the setting.
“SETUP END” appears for a while, then the indication of the
previously selected source appears on the display.
NOTES
• The setting you have made is not registered until “SETUP END”
appears on the display.
• Performing any operation other than volume and dimmer
adjustment cancels Quick Setup process.
• When you want to change the speaker and subwoofer information
after Quick Setup, use Manual Setup (see page 17).
Speaker size according to the number of speakers
Number of Subwoofer Front Center Surround
speakers
3 NO LRG (large) SML (small) NO
3 USE (YES) SML (small) SML (small) NO
4 NO LRG (large) NO SML (small)
4 USE (YES) SML (small) NO SML (small)
5 NO LRG (large) SML (small) SML (small)
5 USE (YES) SML (small) SML (small) SML (small)
Speaker delay time according to room size
C
1.5 m
L R
LS
RS
2.4 m
1.8 m
2.1 m
When selecting “SMALL ROOM,”
• Center speaker delay time
is set to 1 msec.
• Surround speakers delay time
is set to 3 msec.
15-20_RX-ES9SL[B]f 03.6.27, 16:49 16