JVC DM-NC40 - Manual (Page 48)

48
DHCP Operation and IP Address Display during Startup
DHCP Operation
DM-NC40 supports DHCP.
If there is DHCP server in same LAN, network settings, i.e. IP address, subnet mask, default
gateway, are provided from the DHCP server to the unit after power on or rebooting.
After turning on the power or rebooting, the unit displays IP address. If there is DSCP server
in same LAN, provided IP address from the DHCP server will be displayed on the front of the
unit.
If there is no DHCP server, IP address “10 0 0 1” is displayed after about 2 minutes and the
IP address and subnet mask are set to the default values of 10.0.0.1 and 255.0.0.0,
respectively.
Display example when the IP address is 10. 0. 0. 1:
Initialization operation
When DHCP server is not available, network settings by manual may be required. Use Web
browser (see page 30) or API commands described in page 54 to change the setting to
“Manual”.
* Changing from DHCP to Manual is possible from Web browser, but you need to use API
command to change from Manual to DHCP.
* During DHCP is enabled, IP Address, Subnet Mask, Default Gateway, Domain Name and
DNS Server settings cannot be set from Web browser.
IP Address Display
To disable the displaying IP address, see the API commands described in page 54 to turn the
display setting off.
Initialization operation
If the IP address could not be acquired:
After about 2 minutes
The IP address is displayed after the power of DM-NC40 is turned on.
When the power is turned on, the unit performs initialization and current IP address is displayed
twice on the connection number display of the unit.