JVC DM-NC40 - Manual (Page 44)

44
Monitor mode
1.
Set the power to ON.
2.
Enter the camera-side number
3.
Press the PLAY button.
Camera side
Camera side
For use as a Monitor system, the DM-NC40 connected to the camera side is set to the
Camera mode and the DM-NC40 on the monitoring side is set to the Monitor mode.
Operating the Monitor System
Camera mode
1.
Set the power to ON.
Number display
POWER IN 2 IN 1 HOLD DECODE ENCODE
CF PLAY STOP HOLD SELECT P P in
POWER IN 2 IN 1 HOLD DECODE ENCODE
CF PLAY STOP HOLD SELECT P P in
Network Network
1.
Monitoring side
Number display 2. 3. 1.
The number display circles, IP address is displayed as shown
on page 48, and then turns off when ready. The number display circles, IP address is displayed as shown
on page 48, and then turns off when ready.
(Off) (Off)
The entered number will flash.
The sent number will flash.
Memo
• Pressing ̇ or ̈ first will display the number of
the previous connection.
• Use
̇ and ̈ to select the digit to input.
• Use ̄ and ̆ to increment/decrement
the number of the selected digit (0 ~9).
4.
When connection is established:
5.
Press the PinP button
• The display will change to a constant
display and the video of the camera
selected using the SELECT button is
displayed.
• Pressing the SELECT button each time
switches the video between VIDEO IN
1 and VIDEO IN 2.
The display will change to a
constant display.
Video IN 1 and 2 videos will be
displayed simultaneously.
4.
When connection is established:
5.
Press the PinP button
Video IN 1 and 2 videos will be
displayed simultaneously.