Setting (continued) – JVC VN-V686WPU User Manual

Page 44

Encoding Page

This page is for setting JPEG and MPEG4 encoding parameters.

This page can be used during access using

AadminB or AoperatorB.

● Press the [OK] button to enable the new settings.
● If the [OK] button is pressed upon entering an invalid value, a warning message will appear and the entry

will be denied. Press the [Cancel] button to restore the invalid entry to the current value.

● When settings on this page are altered during playback using Built-in viewer, reboot the viewer.
● There is a maximum limit to the bit rate for transmission by VN-V686WPU. If a bit rate that exceeds the

maximum limit is specified, this new setting will not be applied. For details on the maximum transmission
limit, refer to [Network Requirements] (A Page 24).

Setting (continued)

Frame Size

For setting the frame size of each JPEG or MPEG4 screen to

AVGAB (640 x

480) or

AQVGAB (320 x 240).

Select one of the four different patterns.

VN-V686WPU_EN.book Page 44 Friday, February 8, 2008 5:20 PM