Camera mounting procedures – JVC VN-V686WPU User Manual
Page 15
15
Alarm
VN-V686WPU comes with a motion detection
feature and dual alarm input.
By motion detection or alarm input, actions such
as mail delivery, message transmission via TCP/
UDP, alarm output, turning to preset position,
changing B&W mode can be triggered. These
actions can also be triggered by combination of
two alarm inputs.
Installing an FTP server enables uploading of
JPEG images before and after the alarm input
time (pre-/post-recording) to the server.
AJPEG Viewer ConfigurationB (A Page 96)
Computer
Sending JPEG images
before and after alarm
input to FTP
Alarm Device
Network
VN-V686WPU
Restrictions on Clients
VN-V686WPU enables users to authorize or
reject the acquisition of images by specific IP
address.
(A Page 72)
Control via customized application
software
The following uses are also possible by
developing a customized application software
that supports the API of VN-V686WPU.
For details, please refer to [API GUIDE] in the
supplied CD-ROM.
● Monitors via the computer while at the same
time records images to the HDD of the
computer.
● Performs recording by changing the frame
size/frame rate during alarm occurrence.
● Records the type and time of alarm
occurrence on the computer.
Mount the camera using the following procedures.
Step 1 Connection/Installation (A Page 16)
\
G
Step 2 Network settings (A Page 26)
T In a system where multiple units of VN-
V686WPU are used, turn on the power of only
one unit to configure the IP address settings
using the Internet Explorer. Upon doing so, turn
on the power of the second unit and configure
accordingly. Configure the settings for the other
cameras using the same procedure.
G
Step 3 Configuring settings using the
Internet Explorer (A Page 32)
G
Step 4 Operating Built-in viewer
(A Page 91)
Camera Mounting
Procedures
Setting Up the Wall (A Page 16)
● Make holes in the wall
● Install anchor bolts on the wall
Setting Up the Camera (A Page 16)
● Remove the dome cover and remove the
cushioning material
● Heater ON/OFF Switch Setting
● Mount the dome cover
Mounting the camera (A Page 18)
● Install the fall prevention wire (connect the
wall and the camera)
● Secure the camera with anchor bolts
Cable Connection (A Page 18)
● Connection of cables
● Close the cap
● Waterproof treatment
Configure the network settings of the
computer and this camera.
Configure the picture quality and alarm
settings using the Internet Explorer.
Built-in viewers enable you to monitor JPEG and
MPEG4 images and save JPEG images.
VN-V686WPU_EN.book Page 15 Friday, February 8, 2008 5:20 PM