Connecting to an ethernet network, Connect to the network, Connecting to an ethernet network -5 – IBM Print System QMS 4032 User Manual
Page 31: Connect to the network 3-5
"
:+74
9"
$
A start-up page should print, and Serial RS-232C should be listed as an interface.
If it doesn’t, refer to chapter 5, “Troubleshooting Printer Problems,” of the
Opera-
tion
manual.
4
Test the communication between the printer and the computer.
You can do this by sending a file from one of your applications, or refer to chapter
5, “Troubleshooting Printer Problems,” of the
Operation
manual.
4 * .
The QMS CrownNet Ethernet interface combines hardware and host software to allow
printer connection to an Ethernet network. CrownNet supports the following:
The instructions given in this section are the minimum steps needed to get your printer
up and printing. For complete installation information refer to the QMS
CrownNet
Setup Guide
on the QMS
Software Utilities CD-ROM
. For information on configuring
the CrownNet interface and using the CrownNet software (CrownAdmin, CrownAdmin,
CrownNet Manager, and the CrownNet Print Utility for Windows), refer to the QMS
CrownNet System Administrator’s Guide
on the QMS
Software Utilities CD-ROM
.
$ &
The printer provides a twisted-pair (10BaseT/100BaseTX) Ethernet interface.
Twisted-pair Ethernet connections use RJ45 connectors.
Operating System
Protocol
Macintosh
EtherTalk
LAN Manager/LAN Server
NetBIOS/NetBEUI
NetWare
IPX/SPX
UNIX or OS/2
TCP/IP
Windows 3.1/Windows 95/98
TCP/IP/NetBIOS/NetBEUI
Windows NT
TCP/IP/NetBIOS/NetBEUI