IBM Print System QMS 4032 - Manual (Page 30)

4
'
"
.
"# $%
Interface cables are not included with your printer. If you’re replacing a printer, you
may already have the necessary cables. If not, you’ll need to purchase the cables from
your QMS vendor or a local computer store.
To connect your printer to a single computer, you need a serial cable with either a 9- or
25-pin connector (depending on your computer’s serial port) and a 9- or 25-pin null
modem assembly to connect to the serial cable. Depending on the type of null modem
assembly you have, you may also need a 9-to-25-pin adapter. See appendix B, “Tech-
nical Specifications,” in the
Reference guide for cable pin-outs or your cable vendor for
more specific cable assembly information.
'(
& &
For best results, the serial cable should be less than 25 feet (7.6 meters long).
&
1 Turn off both the printer and the computer.
2 Connect the computer and
the printer using a serial
cable.
a Connect the serial cable
(with the null modem
adapter attached) to the
computer’s 9- or 25-pin
male serial port, and tighten
the screws.
b Connect the other end of
the cable to the printer’s
serial port, and tighten the
screws.
3 Turn on both the printer and the computer.