beautypg.com

Before using the dtr-10.5 – Integra DTR-10.5 User Manual

Page 9

background image

9

Before Using the DTR-10.5

Notes:

• The supplied batteries should last for about six

months, although this will vary with usage.

• If the remote controller doesn’t work reliably, try

replacing the batteries.

• Don’t mix new and old batteries, or different types of

batteries.

• If you intend not to use the remote controller for a

long time, remove the batteries to prevent possible
leakage and corrosion.

• Expired batteries should be removed as soon as

possible to prevent damage from leakage or
corrosion.

To use the remote controller, point it at the DTR-10.5’s
remote control sensor, as shown below. The DTR-10.5’s
[Standby] indicator flashes while a signal is being
received from the remote controller.

Notes:

• The remote controller may not work reliably if the

DTR-10.5 is subjected to bright light, such as direct
sunlight or inverter-type fluorescent lights. Keep this
in mind when installing the DTR-10.5.

• If another remote controller of the same type is used

in the same room, or the DTR-10.5 is installed close
to equipment that uses infrared rays, the remote
controller may not work reliably.

• Don’t put anything, such as a book, on the remote

controller, because the buttons may be pressed
inadvertently, thereby draining the batteries.

• The remote controller may not work reliably if the

DTR-10.5 is installed in a rack behind colored glass
doors. Keep this in mind when installing the
DTR-10.5.

• The remote controller will not work if there’s an

obstacle between it and the DTR-10.5’s remote
control sensor.

• You can set the transmission signal format to infrared

(IR), or radio frequency (RF) for use with the
optional RF Receiver. This is useful when, for
example, the DTR-10.5 is installed in a rack or is not
in line of sight of the remote controller.

• To select AMP mode, press the scroll wheel. “AMP”

appears on the display.

Installing the Batteries

1

To open the battery compartment, press
the small hollow and slide off the cover.

2

Insert the three supplied batteries (AA/R6)
in accordance with the polarity diagram
inside the battery compartment.

3

Put the cover onto the remote controller
and slide it shut.

Using the Remote Controller

30˚

30˚

Appr

ox

. 16 ft.

(5 m)

Remote control sensor

Standby indicator

DTR-10.5

Getting Star

ted