Integra DTR-10.5 - Manual (Page 54)

54
Connecting the Power/Basic Operations —Continued
Listening with Headphones
To listen with headphones, plug a pair of headphones
with a standard stereo plug into the Phones jack on the
DTR-10.5 front panel.
• When you connect headphones, no sound will be
heard from the speakers.
• While the Dolby Headphone feature is active,
appears on the front display. Refer to pages 60, 61,
and 119.
Note:
The signal to the remote zone (Zone 2/3) will not be
affected whether or not headphones are connected.
Adjusting the Brightness of the Front Display
You can adjust the brightness of the front display of the
DTR-10.5 using the [Dimmer] button on the remote
controller or on the DTR-10.5 front panel.
Temporarily Turning Off the Sound (remote
controller only)
Use the [Muting] button to temporarily turn off the
sound immediately.
Adjust the Tone
You can adjust bass, mid, and treble notes for each
speaker set. You can also adjust the tone using the setup
menu (see page 118).
ABC DEF
PQRS TUV WXYZ
GHI JKL MNO
@.-'/
--/--- Direct Tuning
#
Custom
Display
Dimmer
T V
Input
Sleep
Muting
On Standby
T V
T V CH
T V VOL
Exit Gu ide
Prev
CH
Enter
Set up Retu
rn
+10 0 Clear
1 2 3
4 5 6
7 8 9
Input
To p M enu Men u
VOL CH
Disc
I
+
-
+
-
Zone 3
Zone 2
Input Mode
Macro
Se rve r Aud io A D J
Phones
Listening Mode Audio Selector Tone Zone 2 Select/ Preset
Push To Enter
Setup Control / Tuning
Push To Enter
Rec/ Zone 3 Digital S Video Video Audio L R Video 7 Input
Level Exit Level Dimmer Memory Tuning
Mode
Clear
Pure Audio Open DVD
Display Tape 1 Tape 2 Tuner Phono C D Net Audio
Video 1 Video 2 Video 3 Video 4 Video 5 Video 6 Video 7
Standby
Master Volume
Rec/ Zone 3 Red ) ( Main Blue ( ) Zone 2 Green ( )
Standby/On
Muting
Dimmer
Dimmer
Select/Preset
Control/Tuning
Tone
Phones
Scroll wheel
Phones
Listening Mode Audio Selector Tone
Dimmer Memory Tuning
Mode
Clear
Use the [Dimmer] button on the
DTR-10.5 to select: normal, dark,
very dark, and volume only.
On the remote controller, press the
scroll wheel, and then press the
[Dimmer] button.
Press the scroll wheel, and then
press the [Muting] button on the
remote controller.
When pressed, “Muting” is displayed on
the DTR-10.5. Press the [Muting] button
again to turn the sound back on.
1 Press the [Tone] button.
2 Turn the [Select/Preset] dial to
select the channel and tone you
want to adjust.
3 Turn the [Control/Tuning] dial to
adjust the tone.
Dimmer
Dimmer
DTR-10.5
Remote
controller
Muting
Remote
controller
DTR-10.5
Tone
Select/ Preset
Control / Tuning