Integra DTR-10.5 - Manual (Page 149)

149
Miscellaneous
Troubleshooting —Continued
“Not available with Headphones use”
• Operation not allowed while a pair of headphones is con-
nected.
“Not available in this Sp Config”
• Doesn’t work with the current speaker configuration.
“Only available with Dolby D”
• Can be used with only Dolby Digital.
“Not available with this signal”
• Doesn’t work with the current listening mode.
“Not available with Muting”
• Operation not allowed because the DTR-10.5 is currently
muted.
“Not available in this Listening Mode”
• Doesn’t work with the current listening mode.
“Not available with NET AUDIO use”
• Operation not possible with Net Audio selected for the
input source.
“Not available with Dolby Headphone Off”
• Doesn’t work with the Dolby Headphone function off.
“Not available with Dolby Headphone On”
• Doesn’t work with the Dolby Headphone function on.
“Not available with zone2 out in Line out”
• Operation not possible with “1-8. f. Zone 2 Out” set to
“Line Out.”
“Not available with zone3 out in Line out”
• Operation not possible with “1-8. g. Zone 3 Out” set to
“Line Out.”
Error Messages
Memory backup
The DTR-10.5 uses a battery-less memory backup system in order to retain radio presets and other settings when it is
unplugged or in the case of a power failure. Although no batteries are required, the DTR-10.5 must be plugged into an
AC outlet in order to charge the backup system.
Once it has been charged, the DTR-10.5 will retain the settings for several weeks, although this depends on the envi-
ronment and time will be shorter in humid climates.
The DTR-10.5 contains a microcomputer for signal processing and control functions. In very rare situations, severe
interference, noise from an external source, or static electricity may cause it to lockup. In the unlikely event that this
happens, unplug the power cord from the wall outlet, wait at least five seconds, and then plug it back in again.
To reset the DTR-10.5 to its factory defaults, turn it on and, while holding down the [Video 1] button, press the [Standby/
On] button. When the reset is complete, “CLEAR” appears on the display and the DTR-10.5 enters Standby mode.
Integra is not responsible for damages (such as CD rental fees) due to unsuccessful recordings caused by the unit’s
malfunction. Before you record important data, make sure that the material will be recorded correctly.