Sample file modem_z.cfg – IBM Enterprise Server H80 Series User Manual

Page 208

Sample File modem_z.cfg

#
# COMPONENT_NAME: (ESPSETUP) ENTRY SERVICE PROCESSOR SETUP Z
#
# FUNCTIONS: Modem configuration file for many early Hayesᑍ compatible modems.
#

This example uses the ATZ reset command to choose the factory defaults.

This setup will work for many modems, but it is required for early vintage

modems which respond to neither the ATZ reset command nor the extended (&)

# commands. Refer to your modem manual.

#
# ᑍ Trademark of Hayes Microcomputer Products, Inc.
#
# (C) COPYRIGHT International Business Machines Corp. 1996
# All Rights Reserved
# Licensed Materials - Property of IBM
#
# US Government Users Restricted Rights - Use, duplication or
# disclosure restricted by GSA ADP Schedule Contract with IBM Corp.
#
#
# If the modem has configuration switches, they should be set to the
# factory default settings.

ICDelay 1
DefaultTO 1
CallDelay 12

# AT Attention Code

Inserts delay in dialing commands

Reset to factory defaults Q

Turn on responses

# E Turn echo off

Turn off responses

# V Use numeric responses

S =

Automatic answer inhibit

# +++

Escape to command mode

S =2 Answer on second ring

# H Hang-up

T = Tone mode. When used as T\r, it is a

no op to maintain program synchronization

when modem may/will echo the commands.

# %N Call-Out phone number

Paging phone number

# %S Modem speed (available to users)

#
# Following are common responses from a wide range of modems:
# 16, 15, 12, 1 , 5 and 1 are connection responses.

Add others as required.

# 7=busy; 6=no dial tone; 4=error; 3=no carrier; 2=ring; =OK
#
# PROGRAMMING NOTE: No blanks between double quote marks (").

condout:

send "ATZQ T\r"

# Reset to factory defaults.

ignore " \r" or "OK\r\n" timeout 2

# Ignore modem response.

send "ATE T\r"

# Initialize modem: Echo OFF,

expect " \r" or "OK\r\n" timeout 2

Enable responses (Numeric),

send "ATQ V T\r"

Limit response codes.

expect " \r" timeout 2

# Confirm commands successful.

send "ATS = \r"

# Set AutoAnswer OFF

expect " \r" timeout 2

# Confirm command successful.

done

connect:

send "ATDT%N\r"

# Tone dialing command.
# %N from Call Home setup.

# Expect a connection response.

expect "16\r" or "15\r" or "14\r" or "12\r" or "1 \r" or "5\r" or "1\r" busy "7\r"

timeout 6

done

retry:

send "A/"

# Repeat the previous command.

# Expect a connection response.

expect "16\r" or "15\r" or "14\r" or "12\r" or "1 \r" or "5\r" or "1\r" busy "7\r"

192

RS/6000 Enterprise Server Model H80 Series User's Guide