Intel SR1450 - Manual (Page 33)

Hardware Installations and Upgrades
Intel ® Server Chassis SR1450 User Guide 33
6. When the black drive carrier lever begins to close by itself, push on it to lock the drive
assembly into place.
TP01602
B
A
Figure 19. Inserting a Hot-swap Hard Disk Drive Assembly into the Chassis
7. (Optional) Install the front bezel. For instructions, see “Removing and Installing the Front
Bezel.”
Installing or Removing a Floppy Drive (Slimline or
Standard)
Floppy drives are installed in different ways, depending on the following items:
ƒ
You want to install the floppy drive into the slimline drive bay.
ƒ You have installed a CD-ROM or DVD-ROM drive into the slimline drive bay. You want to
install the floppy drive into a bay that was intended for a hard drive (optional conversion kit is
required).
Look carefully at the heading titles below before beginning your installation to be sure you are
following the correct instructions for your system.
CAUTION
Floppy drives are NOT hot swappable. Before removing or replacing the
drive, you must first take the server out of service, turn off all peripheral
devices connected to the system, turn off the system by pressing the power
button, and unplug the AC power cord from the system or wall outlet.