IBM MS-7236 (V2.X) Mainboard G52-72361X2 User Manual
Page 59
3-21
BIOS Setup
ACPI Standby State
This item specifies the power saving modes for ACPI function. If your operating
system supports ACPI, such as W indows 98SE, W indows ME and W indows 2000,
you can choose to enter the Standby mode in S1 (POS) or S3 (STR) fashion through
the setting of this field. Options are:
[S1(POS)]
The S1 sleep mode is a low power state. In this state, no
system context is lost (CPU or chipset) and hardware main
tains all system context.
[S3(STR)]
The S3 sleep mode is a lower power state where the infor
mation of system configuration and open applications/files is
saved to main memory that remains powered while most other
hardware components turn off to save energy. The informa
tion stored in memory will be used to restore the system
when a
“wake up” event occurs.
Suspend Time Out
If system activity is not detected for the length of time specified in this field, all
devices except CPU will be shut off. Settings: [Disabled], [1min], [2min], [4min], [8min],
[10min], [20min], [30min], [40min], [50min], [60min].
Power Button M ode
This feature allows users to configure the Power Button function. Settings are:
[On/ Off]
The power button functions as a normal power-on/-off button.
[Suspend]
W hen you press the power button, the computer enters the
supend sleep mode, but if the button is pressed for more than
four seconds, the computer is turned off.
Restore on AC Power Loss
This setting specifies whether your system will reboot after a power failure or
interrupt occurs. Available settings are:
[Power Off]
Leaves the computer in the power off state.
[Power On]
Leaves the computer in the power on state.
[Last State]
Restores the system to the previous status before power
failure or interrupt occurred.
Wakeup Event Setup
Press