IBM CICS Transaction Server for OS/390 SC33-1686-02 - Manual (Page 47)

CEBT SET INTTRACE CEBT SET SURVEILLANCE
CEBT SET INTTRACE
Function: Switch CICS internal tracing on or off.
Description: This command is intended for use at
terminals that do not support the full-screen tracing
transaction CETR.
Syntax: Press the Clear key to clear the screen. There are
two ways of commencing this transaction:
Type CEBT SET INTTRACE (the minimum abbreviation is
CEBT S IN ). You get a display that lists the current
status, similar to that obtained by CEBT INQUIRE
INTTRACE. You can then tab to the highlighted or blank
fields and overtype them with the required values.
Type CEBT SET INTTRACE ( CEBT S IN ) followed by one or
more attribute settings that you wish to change. For
example,
CEBT S IN STO will stop internal tracing if it is
already running.
─ ─ ─CEbt Set Inttrace ─ ─┬ ┬ ─────── ─
├ ┤ ─STArt─
└ ┘ ─STOp──
Options
STArt
CICS internal tracing is started.
STOp
CICS internal tracing is stopped.
CEBT SET SURVEILLANCE
Function: Set surveillance (or tracking) of the active CICS
by the alternate CICS on or off.
Syntax
─ ─ ─CEBT Set Surveillance ─ ─┬ ┬ ───── ─
├ ┤ ─OFf─
└ ┘ ─ON──
Options
OFf
Surveillance of the active CICS system by the alternate
CICS is to be stopped.
ON
Surveillance of the active CICS system by the alternate
CICS is to be started.
For more information about surveillance, see the
CICS/ESA 3.3 XRF Guide.
Chapter 7. Master terminal (alternate CICS) CEBT 29