Intel Core 2 Duo - Manual (Page 29)

Intel ® Core TM 2 Duo Processor and Intel ® Q35 Express Chipset Development Kit
October 2007 User’s Manual
Order Number: 318476001US 29
Setting Up and Configuring the Development Kit—Intel Core 2 Duo Processor and Intel Q35
Express Chipset
1. Place the uBTX board on the Support and Retention Module (SRM) so that the holes
A, B, C and D on the PCB line up with the corresponding locations on the SRM (see
Figure 19 ). The board and SRM assembly should look like Figure 20 .
2. Place the heatsink on top of the processor. The heatsink should align with the holes
on the SRM and board as shown below Figure 21 . Clean the surface of the
processor with isopropyl alcohol before attaching the heatsink.
3. Use two 6-32 screws to partially tighten the rear end of the heatsink to the board
and the SRM as shown in Figure 22 . The screw uses the threaded holes of the SRM
for retention.
Figure 20. BTX board alignment on SRM
Figure 21. Heatsink Alignment