IBM POWERPC 750GL - Manual (Page 11)

User’s Manual
IBM PowerPC 750GX and 750GL RISC Microprocessor
750gx_umTOC.fm.(1.2)
March 27, 2006
Page 11 of 377
11.1 Performance-Monitor Interrupt .................................................................................................... 349
11.2 Special-Purpose Registers Used by Performance Monitor ......................................................... 350
11.2.1 Performance-Monitor Registers ......................................................................................... 351
11.2.1.1 Monitor Mode Control Register 0 (MMCR0) ............................................................... 351
11.2.1.2 User Monitor Mode Control Register 0 (UMMCR0) .................................................... 351
11.2.1.3 Monitor Mode Control Register 1 (MMCR1) ............................................................... 351
11.2.1.4 User Monitor Mode Control Register 1 (UMMCR1) .................................................... 351
11.2.1.5 Performance-Monitor Counter Registers (PMCn) ...................................................... 351
11.2.1.6 User Performance-Monitor Counter Registers (UPMC1–UPMC4) ............................ 354
11.2.1.7 Sampled Instruction Address Register (SIA) .............................................................. 355
11.2.1.8 User Sampled Instruction Address Register (USIA) ................................................... 355
11.3 Event Counting ............................................................................................................................ 355
11.4 Event Selection ........................................................................................................................... 356
11.5 Notes ........................................................................................................................................... 356
11.6 Debug Support ............................................................................................................................ 357
11.6.1 Overview ............................................................................................................................ 357
11.6.2 Data-Address Breakpoint .................................................................................................. 357
11.7 JTAG/COP Functions .................................................................................................................. 357
11.7.1 Introduction ........................................................................................................................ 357
11.7.2 Processor Resources Available through JTAG/COP Serial Interface ............................... 357
11.8 Resets ......................................................................................................................................... 359
11.8.1 Hard Reset ........................................................................................................................ 359
11.8.2 Soft Reset .......................................................................................................................... 359
11.8.3 Reset Sequence ................................................................................................................ 360
11.9 Checkstops ................................................................................................................................. 361
11.9.1 Checkstop Sources ........................................................................................................... 361
11.9.2 Checkstop Control Bits ...................................................................................................... 361
11.9.3 Open-Collector-Driver States during Checkstop ............................................................... 362
11.9.4 Vacancy Slot Application ................................................................................................... 362
11.10 750GX Parity ............................................................................................................................. 363
11.10.1 Parity Control and Status ................................................................................................. 364
11.10.2 Enabling Parity Error Detection ....................................................................................... 364
11.10.3 Parity Errors ..................................................................................................................... 364
Acronyms and Abbreviations ................................................................................... 365
Index ............................................................................................................................ 369
Revision Log .............................................................................................................. 377