Midland Radio SYN-TECH III P25 - Manual (Page 17)

Syn-Tech III P25 Portable Radio
OPERATION MANUAL
680-090-2040
Version 6.0
http://www.midlandradio.com
9
3.2.12.2 Setting Current Status
Successive presses of the # key may prompt “CUR. STATUS:” to set the current status.
This function is only available in digital mode. The current status is used when sending
status to other users, or when other users request the current status. The current status
may also be set under MENU | STATUS | PRESENT STATUS.
Sending current status and requesting status from other users may be
disabled in radio programming. You may still set current status and
receive status messages from other users.
3.2.12.3 Entering Individual Call Mode
Successive presses of the # key may prompt “INDIVIDUAL:” to enter individual call
mode. This function is only available in digital mode. A unit ID may be entered or
selected from the index list. Once a unit ID is selected, the radio will enter individual call
mode. The radio will transmit unit to unit calls to the entered unit ID each time PTT is
pressed. If PTT is not pressed and no signal is received the individual call mode will
time out after ten seconds.
Individual calling may be disabled by radio programming.
3.2.12.4 Initiating a Telephone Interconnect Request
Successive presses of the # key may prompt “DIAL TELEPHONE NUMBER” to initiate
a telephone call. This function is only available in digital mode. This function initiates a
telephone interconnect request on the RF subsystem.
Telephone dialing may be disabled or the number of dial digits may be
limited by radio programming.
3.2.12.5 Sending a Call Alert
Successive presses of the # key may prompt “CALL ALERT:” to initiate a call alert
transmission. This function is only available in digital mode.
Call alert transmissions may be disabled by radio programming.
3.2.12.6 Transmitting a Selective Call
Successive presses of the # key may prompt “SELECTIVE CALL” to transmit a
selective call. This function is only available in analog mode.